It is designed to deliver everything the original t cell 15 already does but with an additional 25 lifespan.
Aqua rite t cell 15 installation.
I had removed the t cell for winter and i m getting ready to open the pool but i don t recall which direction the t cell was placed by the installers.
If you are replacing an existing glx cell 15 w chlorinator cell as we are showing here no re configuration of the digital controller is necessary.
The models are shown below.
I ve attached a photo of the way i ve installed it but i m not sure if it even makes a difference whether the corded section is closest to the heater or closest to the filter.
The aqua rite will remind you to do this by flashing the inspect cell led after approximately 500 hours of operation.
The aqua rite salt generator comes from the factory preset for a t cell 15.
The models are shown below.
Consult local plumbing codes.
While both the t cell 15 and the t cell 15ll can support pools up to 40 000 gallons in size the regular t cell 15 is designed to produce around 580lbs of chlorine throughout its life before it needs to be replaced.
To set turbo cell type.
Before operation the aqua rite must be configured for the chlorinator cell that will be used.
Plumbing ensure that the aqua rite installation does not constitute a cross connection with the local potable water supply.
This guide describes how to replace a glx cell 15 w turbo cell in a aqua rite electronic chlorine generator.
Refer to the following information and steps below to set the turbo cell type.
Choose the appropriate cell based on the size of your pool.
The aqua rite is packaged with a flow switch and cell unions.
The cell must be pur chased separately.
Cells are not included with the aqua rite and must be purchased before installation.
T cell 15 for pools up to 40 000 gallons t cell 9 for pools up to 25 000 gallons t cell 3 for pools up to 15 000 gallons.
To do this place the power switch in the auto position and then press the diagnostic button eight times from the default.
Maintaining the aqua rite system to maintain maximum performance it is recommended that you open and visually inspect the cell every 3 months or after cleaning your filter.
If installing a t cell 3 or t cell 9 the configuration of the control box must be changed in order to be able to control the correct cell.
Choose the appropriate cell based on the size of your pool.
T cell 15 for pools up to 40 000 gallons t cell 9 for pools up to 25 000 gallons t cell 3 for pools up to 15 000 gallons note that the installation.